LED TUBE LIGHT MANUFACTURER

Material technics	aluminium alloy of high heat conductivity and patented configuration technics
Lighting source	Low light-declining LED, long lifetime, energy saving, high efficiency and enviroment protective
Nti-electric shock rate	Class II
Electric Parts	outside the fixture
Beam angle	120
Lenz	frosting cover
Installation place	indoor

How to Install LED Tube Light

LED tube lights installation is relatively simple to do it in an existing fluorescent fixture.

If the fixture has electronic ballast, you need to remove that and then wire the power directly to the end sockets which the LED tube light has a standard bi-pin.

This is fairly simple, and typically you can use the existing wire in the fixture and then just add some wire nuts.

If you have an older fixture with a magnetic ballast and starter, you will have to remove or open the starter and remove or short the magnetic ballast.

Normally, LED tube light replacements incorporate large arrays of LEDs. Remember, of course, that when servicing a fluorescent fixture or lamp for any reason, electrical power to the entire fixture should be disconnected.

This is not always practical in situations where a large number of fixtures are controlled from the same power control (such as in open office areas).

In these cases, insulating gloves and a nonmetallic ladder should be used if the fixtures must be serviced when power is present. LED tube lights feature the highest quality LEDs, emitting the same amount of brightness as a conventionalist.

T8 LED tube lights represent the latest advancement in environmental lighting technology. There are many people who are trying for ways to make the surroundings better. These people are those like scientists and research workers who are working to provide an alternative to the fluorescent tubes.